Rotary ultrasonic machining of CFRP/Ti stacks using variable feedrate
| dc.citation.doi | 10.1016/j.compositesb.2013.04.022 | en_US |
| dc.citation.epage | 310 | en_US |
| dc.citation.jtitle | Composites Part B: Engineering | en_US |
| dc.citation.spage | 303 | en_US |
| dc.citation.volume | 52 | en_US |
| dc.contributor.author | Cong, W. L. | |
| dc.contributor.author | Pei, Zhijian J. | |
| dc.contributor.author | Deines, Timothy W. | |
| dc.contributor.author | Liu, D. F. | |
| dc.contributor.author | Treadwell, C. | |
| dc.contributor.authoreid | zpei | en_US |
| dc.contributor.authoreid | tdeines | en_US |
| dc.date.accessioned | 2013-08-16T21:12:22Z | |
| dc.date.available | 2013-08-16T21:12:22Z | |
| dc.date.issued | 2013-09-01 | |
| dc.date.published | 2013 | en_US |
| dc.description.abstract | Rotary ultrasonic machining (RUM) has been successfully used to drill Ti (titanium and its alloy), CFRP, and CFRP/Ti stacks. In all studies on RUM reported in the literature, feedrate was fixed during each experimental test. It has been shown that low feedrate should be used for RUM of Ti, but RUM of CFRP could be done using feedrate ten times higher. This paper, for the first time, reports a study on RUM of CFRP/Ti stacks using variable feedrate (high feedrate for CFRP and low feedrate for Ti). It also makes comparisons on RUM of CFRP/Ti stacks using fixed and variable feedrate. | en_US |
| dc.description.version | Article: Accepted Manuscript | |
| dc.identifier.uri | http://hdl.handle.net/2097/16298 | |
| dc.language.iso | en_US | en_US |
| dc.relation.uri | http://doi.org/10.1016/j.compositesb.2013.04.022 | en_US |
| dc.rights | This Item is protected by copyright and/or related rights. You are free to use this Item in any way that is permitted by the copyright and related rights legislation that applies to your use. For other uses you need to obtain permission from the rights-holder(s). | |
| dc.rights.uri | https://rightsstatements.org/page/InC/1.0/ | |
| dc.subject | Polymer-matrix composites | en_US |
| dc.subject | Joints/joining | en_US |
| dc.subject | Machining | en_US |
| dc.subject | CFRP/Ti stacks | en_US |
| dc.title | Rotary ultrasonic machining of CFRP/Ti stacks using variable feedrate | en_US |
| dc.type | Text | en_US |
