Modeling, analysis, and experimental investigations of grinding processes

Date

2006-09-05T14:11:27Z

Journal Title

Journal ISSN

Volume Title

Publisher

Kansas State University

Abstract

Grinding is one of the important operations employed in modern manufacturing industry to remove materials and achieve desired geometry and surface finish. Simultaneous double side grinding (SDSG) and ultrasonic vibration assisted grinding (UVAG) are two typical cost-effective grinding processes which are utilized to grind semiconductor materials and high performance ceramic materials, respectively. The objectives of this research are to investigate several technical issues in modern grinding processes by using theoretical, numerical, and experimental research approaches. Those technical issues are related to SDSG and UVAG, which have been chosen as two typical grinding processes for this research. This thesis reviews the literature on SDSG (covering process applications, modeling of grinding marks, and modeling of wafer shapes) and UVAG (covering process applications, edge chipping, and coolant effects, etc). The theoretical research work of this thesis is conducted by developing mathematical models for grinding marks and wafers shapes in SDSG of silicon wafers. These developed models are then used to study the effects of SDSG parameters on the curvature of the grinding marks, the distance between adjacent grinding marks, and the wafer shapes. The numerical research work of this thesis is done by conducting a three dimensional (3-D) finite element analysis (FEA) of UVAG process. A 3-D FEA model is developed to study the edge chipping commonly observed in UVAG of ceramics. Edge chippings not only compromises geometric accuracy but also possibly causes an increase in machining cost. A solution to reduce the edge chipping is proposed based upon the FEA simulations and validated by pilot experiments. Several experimental studies are conducted to provide new knowledge for the UVAG process. Firstly, a novel coolant delivery system is explored for UVAG machine system. Secondly, UVAG is introduced into machining of fiber-reinforced ceramic matrix composites (CMC). Results of a feasibility study and a designed experimental investigation show that UVAG is a promising process for CMC machining. Finally, an experimental study on cutting forces during UVAG of zirconia/alumina composites is conducted. The feasibility to machine different zirconia/alumina composites using UVAG is also investigated and discussed. The findings in this thesis will provide theoretical and practical guidance for modern grinding processes especially for SDSG and UVAG.

Description

Keywords

Ceramics, Finite Element Analysis, Grinding, Machining, Semiconductor

Graduation Month

August

Degree

Doctor of Philosophy

Department

Department of Industrial & Manufacturing Systems Engineering

Major Professor

Zhijian Pei

Date

2006

Type

Dissertation

Citation