Inductive and non-inductive load tests on type ATB - form E General Electric Co. alternator

K-REx Repository

Show simple item record

dc.contributor.author Harold, William H.
dc.contributor.author Burt, Harvy Anson
dc.contributor.author Fulton, Robert Anson
dc.date.accessioned 2017-09-20T21:53:09Z
dc.date.available 2017-09-20T21:53:09Z
dc.identifier.uri http://hdl.handle.net/2097/37778
dc.description Citation: Harold, William H., Burt, Harvy Anson, and Fulton, Robert Anson. Inductive and non-inductive load tests on type ATB - form E General Electric Co. alternator. Senior thesis, Kansas State Agricultural College, 1905.
dc.description.abstract Introduction: The generator tested for characteristic action under different load conditions is of the revolving field, separately excited, stationary armature type. The above drawing shows the principal points in the construction of the machine. On the left is the main pulley which is run by the main drive belt; on the right is a smaller one from which a small direct current generator is run for exciting the alternator field. The shaft is lubricated by rings which dip into an oil reservoir. The revolving field receives its exciting current from the exciter through two slip rings. The field spider and pole faces are of laminated steel that in the pole faces is japanned and that in the spider is not. These laminations are held together by bolts as shown in drawing. The armature ring is built of japanned laminations which are held together by bolts and clamps. If the laminations should for any reason become loose and cause a disagreeable humming they may readily be tightened. There are six field coils which are wound as shown; all coils are in series each adjacent one being wound opposite and the terminals brought to the slip rings. One brush on the ring is shown; there are two brushes on each ring. The scheme of an armature slot is shown on drawing and is the construction most commonly employed by modern dynamo builders
dc.rights Public Domain Mark 1.0
dc.rights.uri http://creativecommons.org/publicdomain/mark/1.0/
dc.subject Theory of Alternators
dc.subject Saturation Curves
dc.subject Synchronous Impedance
dc.title Inductive and non-inductive load tests on type ATB - form E General Electric Co. alternator
dc.type Text
dc.date.published 1905
dc.subject.AAT Theses


Files in this item

This item appears in the following Collection(s)

Show simple item record

Public Domain Mark 1.0 Except where otherwise noted, the use of this item is bound by the following: Public Domain Mark 1.0

Search K-REx


Advanced Search

Browse

My Account

Statistics








Center for the

Advancement of Digital

Scholarship

118 Hale Library

Manhattan KS 66506


(785) 532-7444

cads@k-state.edu